ASTM B404/B404M-02 pdf free.Standard Specification for Aluminum and Aluminum-Alloy Seamless Condenser and Heat-Exchanger Tubes with Integral Fins. When measurements are made, transversecross sections of 3 or more tubes per each 1000 lb orfraction thereof in the lot...
ASTM B406-96 pdf free
ASTM B406-96 pdf free.Standard Test Method for Transverse Rupture Strength of Cemented Carbides. Specimens shall be ground to a surface finish of 15 uin.(0.381 um) rms maximum on four sides, and to the tolerancesspecified in Section 5.All...
ASTM B407-01 pdf free
ASTM B407-01 pdf free.Standard Specification for Nickel-Iron-Chromium Alloy Seamless Pipe and Tube. Whenever possible, all pipe and tube shall be tested infull tubular size. When testing in full tubular size is notpossible,longitudinal strip specimens， or the largest...
ASTM B408-01 pdf free
ASTM B408-01 pdf free.Standard Specification for Nickel-Iron-Chromium Alloy Rod and Bar. Representative samples fromeach lot shall be taken during pouring or subsequent processing.Product (check) analysis shall be wholly the re-sponsibility of the purchaser.Mechanical Properties and Grain Size-Samples...
ASTM B409-01 pdf free
ASTM B409-01 pdf free.Standard Specification for Nickel-Iron-Chromium Alloy Plate, Sheet, and Strip. There shall be no flatness requirements for“deepdrawing quality?' and“spinning quality"' sheet and strip (seeX1.1.3). Standard flatness tolerances for plate shall conform tothe requirements of Table...
ASTM B411/B411M-01 pdf free
ASTM B411/B411M-01 pdf free.Standard Specification for Copper-Nickel-Silicon Alloy Rod and Bar. The material of manufacture shall be cast billets oringots of Copper Alloy UNS No.C64700 of such soundnessand structure that they are suitable for processing into thedesired...
ASTM B413-97a pdf free
ASTM B413-97a pdf free.Standard Specification for Refined Silver. The value of this material is such that special attentionmust be paid to sampling procedures.If the purchaser and themanufacturer agree that samples most representative of theassay value of a...
ASTM B415-98 pdf free
ASTM B415-98 pdf free.Standard Specification for Hard-Drawn Aluminum-Clad Steel Wire. When resistance measurements are made at temperatures other than 20°C, corrections shall be based on thecorresponding temperature coefficient of resistance shown inTable 2.The electrical resistivity of the...
ASTM B416-98 pdf free
ASTM B416-98 pdf free.Standard Specification for Concentric-Lay-Stranded Aluminum-Clad Steel Conductors. The breaking strength of the completed conductorscomposed of 7 wires,19 wires, and 37 wires shall be taken as90 % of the sum of the breaking strengths of...
ASTM B417-00 pdf free
ASTM B417-00 pdf free.Standard Test Method for Apparent Density of Non-Free-Flowing Metal Powders Using the Carney Funnel. The test specimen shall consist of a volume of approxi-mately 30 to 40 cm of metal powder obtained in accordancewith...