IEEE 260.3-1993 (R2006) pdf free.American National Standard Mathematical Signs and Symbols for Use in Physical Sciences and Technology. IEEE 260.3 In general, this Standard favors the notation, definition, and meaning given in Reference 2 wherever disagreementexists with...
IEEE 145-1993 pdf free
IEEE 145-1993 pdf free.IEEE Standard Definitions of Termsfor Antennas. IEEE 145 an atenna in a given direction is that of the plane wave it radiates at large distances in that direction. By re-iprocity, a plane wave coming...
IEEE 18-1992 pdf free
IEEE 18-1992 pdf free.IEEE Standard for Shunt Power Capacitors. IEEE 18 The capacitance shall be measured on each unit both before and after the application of the test voltage.Theinitial capacitance measurement shall be at low voltage. The...
IEEE 463-1993 pdf free
IEEE 463-1993 pdf free.IEEE Standard for Electrical Safety Practices in Electrolytic Cell Line Working Zones. IEEE 463 Circuits supplying power to hand-held, cord-connected equipment used within cell line working zone shall a)Be ungrounded b)Be supplied by insulating...
IEEE 610.13-1993 pdf free
IEEE 610.13-1993 pdf free.IEEE Standard Glossary of Computer Languages. IEEE 610.13 HPGL (Hewlett-Packard Graphics Lan-guage). A page description language used by manylaser printers. IAL(International Algebraic Language).Aforerunner of the ALGOL language. ICES (Integrated Civil Engineering Sys-tem). A general-purpose...
IEEE 524a-1993 pdf free
IEEE 524a-1993 pdf free.IEEE Guide to Grounding During the lnstallation of Overhead Transmission Line Conductors. IEEE 524a conductor grip: A device designed to permit the pulling of conductor without splicing on fittings,eyes, etc. It permits the pulling...
IEEE 524-1992 pdf free
IEEE 524-1992 pdf free.IEEE Guide to the Installation of Overhead TransmissionL ine Conductors. IEEE 524 puller, bullwheel: A device designed to pull pulling lines and conductors during stringing operations. It normally incorporates one or more pairs of...
IEEE 519-1992 pdf free
IEEE 519-1992 pdf free.IEEE Recommended Practices and Requirements for Harmonic Controlin Electrical Power Systems. IEEE 519 Single-Phase Inverters. The single-phase inverters for dispersed generation gener-ally are rated for less than 10 kW and typically would cause no...
IEEE C57.19.00-1991 pdf free
IEEE C57.19.00-1991 pdf free.IEEE Standard General Requirements and Test Procedure for Outdoor Power Apparatus Bushings. IEEE C57.19.00 During the cantilever test, the bushing internal pressure (gauge) shall be 69 kPa(10 1bin2).The temperature shall be approximately 25 C.The...
IEEE C57.21-1990 (R2004) pdf free
IEEE C57.21-1990 (R2004) pdf free.IEEE Standard Requirements,Terminology, and Test Code for ShuntReactors Rated Over 500 kVA. IEEE C57.21 Low-Frequency Overvoltage Test for Oil-lmmersed Shunt Reactors 1)The low-frequency overvoltage test for shunt reactors shall consist of a one-hour...