BS ISO 3584:2020 pdf free.Road vehicles — Clevis couplings — Interchangeability.
1.Scope:This document specifies the characteristics necessary for the mounting and interchangeability of cleviscouplings on the frame (cross member, drawbeam or mounting bracket) of towing vehicles for trailers.This document is applicable to clevis couplings intended for connection to trailers equipped with adrawbar eye on the drawbar of the trailer.
Characteristics not specified are left to the discretion of the component manufacturer.
2Normative references:The following documents are referred to in the text in such a way that some or all of their contentconstitutes requirements of this document. For dated references,only the edition cited applies. Forundated references, the latest edition of the referenced document (including any amendments) applies.Iso 1102,Commercial road vehicles — 50 mm drawbar eye — Interchangeability
ISO8718,Road vehicles — Drawbar couplings and eyes for hinged drawbars —Strength testsISO 8755, Commercial road vehicles — 40 mm drawbar eye – Interchangeability
ISO 12357,Commercial road vehicles — Drawbar couplings and eyes for rigid drawbars
3.Terms and definitions:No terms and definitions are listed in this document.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
ISo online browsing platform: available at https:.//www.iso.org/obp
IEC Electropedia: available at http://www.electropedia.org/
4 Designation
4.1 Reference may be made to this document both for clevis coupling mounting dimensions on theframe and for the separate clevis coupling.
4.2 Frames in conformance with this document shall be identified by the following information, in theorder given:
a) reference to this document;
b)number of the category according to Table 1.
EXAMPLE Frames with mounting dimensions according to category 3:Crossmember (or drawbeam or mounting bracket) ISO 3584—Category 3
4.3 Clevis couplings meeting the requirements of this document shall be identified by the followinginformation, in the order given:
5.2 Dimensional requirements on frame for mounting clevis coupling
Dimensions on the frame required for mounting of the clevis coupling (see Figure 2), such as theminimum flat surface defined by dimensions F and G, shall be as given in Table 2. Tolerances on drillingpattern dimensions shall be as shown in Figure 1.
6.1 General
The requirements of 6.2 to 6.4 are applicable to all clevis couplings.Additional requirements applicableto C 40,C 50 and classified clevis couplings of both dimensions are given in 6.5.
6.2 Load requirements
The clevis coupling shall satisfy the tests specified in ISO 8718 or ISO 12357 or both.6.3 Dimensional requirements
The maximum outer dimensions of all components of the clevis coupling shall be within the envelopebox defined in Table 3 (see Figure 3).
In order to permit safer operation of the clevis coupling, there shall be adequate free space aroundactuating devices. Dimensions needed to ensure operating clearance for actuating devices are alsoshown in Figure 3.BS ISO 3584 pdf download.