ASTM B535-04 pdf free.Standard Specification for Nickel-Iron-Chromium-Silicon Alloys (UNS N08330 and N08332) Seamless Pipe and Tube.
This specification2 covers alloys UNS N08330 andN08332 in the form of hot-finished and cold-finished seamlesspipe and tube intended for heat resisting applications andgeneral corrosive service.The values stated in inch-pound units are to be consid-ered as the standard.The values given in parentheses are forinformation only. This standard does not purport to address all of thesafety concerns，if any,associated with its use. lt is theresponsibility of the user of this standard to become familiarwith all hazards including those identified in the appropriateMaterial Safety Data Sheet for this product/material as pro-vided by the manufactureer; to establish appropriate safety andhealth practices，and determine the applicability of regulatorylimitations prior to use.
Referenced Documents2.1 ASTM Standards: B829 Specification for General Requirements for Nickeland Nickel Alloy Seamless Pipe and Tube B899 Terminology Relating to Non-ferrous Metals andAlloys Definitions for terms defined in Terminology B899shall apply unless otherwise defined by the requirements of thisdocument.Material furnished under this specification shall con-form to the applicable requirements of Specification B 829unless otherwise provided herein.It is the responsibility of the purchaser to specify allrequirements that are necessary for material ordered under thisspecification. Examples of such requirements include, but arenot limited to, the following: Alloy name or UNS number,ASTM designation and year of issue,5.1.3 Dimensions: Pipe-Specify standard pipe size and schedule,5.1.3.2 Tube—Specify outside diameter and nominal orminimum wall, Length (specific or random),5.1.4 Finish:Specify cold-worked or hot-worked,5.1.4.2 Tube—Specify cold-worked or hot-finished,5.1.5 Quantity (feet or meters or number of pieces),5.1.6 Certification- State if certification is required, Samples for Product (Check) Analysis—State whethersamples for product analysis should be furnished, If purchaser wishes to witnesstests or inspection of material at place of manufacture,thepurchase order must so state indicating which test or inspec-tions are to be witnessed.The material shall be furnished in theannealed condition.The final heat treatment of UNS N08330shall be 1900°F (1040°C) minimum.The final heat treatmentof UNS N08332 shall be 2100°F (1150C) minimum.ASTM B535 pdf download.