ISO 21111-4-2020 pdf free.Road vehicles —In-vehicle Ethernet — General requirements and test methods of optical gigabit Ethernetcomponents.
1.Scope:This document specifies the optical components requirements and test methods for optical gigabittransmission of in-vehicle Ethernet.Safety (electrical safety, protection, fire, etc.) and electromagneticcompatibility (EMC) requirements are outside the scope of this document.
2.Normative references:The following documents are referred to in the text in such a way that some or all of their contentconstitutes requirements of this document.For dated references, only the edition cited applies.Forundated references, the latest edition of the referenced document(including any amendments) applies.ISO/IEC/IEEE 8802-3:2017/Amd 9:2018, Physical Layer Specifications and Management Parameters for10oo Mb/s Operation over Plastic Optical Fibre.ISO 8092-2,Road vehicles — Connections for on-board electrical wiring harnesses — Part 2: Definitions,test methods and general performance requirements.ISO 8092-3,Road vehicles —Connections for on-board electrical wiring harnesses — Part 3: Tabs for multi-pole connections -Dimensions and specific requirements.ISO 16750-1，Road vehicles — Environmental conditions and testing for electrical and electronicequipment — Part 1: General.ISO 16750-3:2012,Road vehicles — Environmental conditions and testing for electrical and electronicequipment—Part 3: Mechanical loads.ISO 16750-4:2010，Road vehicles — Environmental conditions and testing for electrical and electronicequipment —Part 4 : Climatic loads.ISO 16750-5，Road vehicles – Environmental conditions and testing for electrical and electronicequipment—Part 5: Chemical loads.ISO 21111-1, Road vehicles — In-vehicle Ethernet —General information and definitions.IEC 60068-2-60,Environmental testing — Part 2:Tests —Test Ke:Flowing mixed gas corrosion testIEC 60793-1-20,0ptical fibres — Part 1-20:Measurement methods and test procedures —Fibre geometryIEC60793-1-21,Optical fibres — Part 1-21:Measurement methods and test procedures—Coating geometryIEC 60793-1-40,0ptical fibres —Part 1-40:Attenuation measurement methods
IEC 60793-2-40, Optical fibres —Part 2-40: Product specifications —Sectional specification for categoryA4 multimode fibres
IEC 60793-1-43,Optical fibres — Part 1-43:Measurement methods and test procedures — Numericalaperture measurement
IEC 60793-1-51,Optical fibres — Part 1-51:Measurement methods and test procedure – Dry heat (steadystate) tests
IEC 60794-1-21，Optical fibre cables — Part 1-21: Generic specification — Basic optical cable testprocedures — Mechanical tests methods
IEC 60794-2-41, Optical fibre cables — Part 2-41:Indoor cables — Product specification for simplex andduplex buffered A4 fibres
IEC61300-3-53,Fibre optic interconnecting devices and passive components—Basic test and measurementprocedures —Part 3-53: Examinations and measurements —Encircled angular flux (EAF) measurementmethod based on two-dimensional far field data from step index multimode waveguide (including fibre)ANSI/EIA364-13,Mating and Un-mating Force Test Procedure for Electrical Connectors and SocketsEIA364-38,Cable pull-out test procedure for electrical connectors.EIA/TIA 455-13A, Visual and mechanical inspection of fibre optic components, devices, and assembliesEIA/TIA 455-20A, Measurement of Change in Optical Transmittance.EIA/TIA 455-34A, Interconnection Device Insertion Loss Test.ISO 21111 pdf download.