BS ISO 36:2020 pdf free.Rubber, vulcanized or thermoplastic—Determination of adhesion to textile fabrics.
This document specifies a method of test for measuring the force required to separate, by stripping.two plies of fabric bonded with rubber, or a rubber layer and a fabric ply bonded together.The method is applicable when the ply surfaces are approximately plane or when they are in theform of a cylinder having an internal diameter greater than approximately 50 mm.The method is notapplicable when the ply surfaces contain sharp bends, angles or other gross irregularities which cannotbe excluded when cutting out test pieces.This document does not apply to coated fabrics, which are tested in accordance with ISO 2411,or textileconveyor belts, which are tested in accordance with [SO 252.
The following documents are referred to in the text in such a way that some or all of their contentconstitutes requirements of this document. For dated references,only the edition cited applies. Forundated references, the latest edition of the referenced document (including any amendments) applies.ISO 5893:2019,Rubber and plastics test equipment — Tensile, flexural and compression types (constantrate of traverse) —Specification
ISO 6133;2015,Rubber and plastics — Analysis of multi-peak traces obtained in determinations of tearstrength and adhesion strength.
ISO 18899:2013, Rubber — Guide to the calibration of test equipment.
ISO 23529,Rubber – General procedures for preparing and conditioning test pieces for physicaltest methods.
For the purposes of this document, the following terms and definitions apply.
ISO and lEC maintain terminological databases for use in standardization at the following addresses:
ISo online browsing platform: available at https://www.iso.org/obp
IEC Electropedia: available at http://www.electropedia.org/
force per unit width required to cause a separation at the interface between the assembled componentsNote 1 to entry: Any separation occurring at any other point, for example inside either component under test,is a failure of the component material, and does not indicate an adhesion strength. In such cases, the adhesionstrength is greater than the strength of the weakest component involved.BS ISO 36 pdf download.