ANSI/AGMA 6001-F19 pdf free.American National Standard Design and Selection of Components for Enclosed Gear Drives.
The equations in this standard are not applicable when gear drives are subjected to conditions that introduce vibrations of a sufficient level to affect the performance of the gear drive and may result in unpredictable fatigue failure.
The procedure for design or selection of the specific gear components is varied and complex and is beyond the scope of this standard. Designers must refer to the specific rating or enclosed drive standards for this aspect of drive design.
1.2 Intended use
The equations and values presented provide a general approach to design. Deviations from the methods and values stated in this standard may be made when justified by experience, testing, or more specific analysis. This standard is intended for use by experienced gear designers capable of selecting reasonable values based on their knowledge of the performance of similar designs and the effect of such items as lubr,cation, deflection, manufacturing tolerances, metallurgy, residual stresses, and system dynamics. It is not intended for use by the engineering public at large.
2 Normative references
The following documents contain provisions which, through reference in this text, constitute provisions of this American National Standard. At the time of publication, the editions were valid. All standards are subject to revision, and parties to agreements based on this standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below.
ANSI B17.1, Keys and Keyseats
ANSI Bi 7.2, Woodruff Keys and Keyseats
AGMA 927-AOl, Load Distribution Factors — Analytical Methods for Cylindrical Gears
AGMA 938-A05, Shot Peening of Gears
ANSI/AG MA 101 2-G05, Gear Nomenclature, Definitions of Terms with Symbols
ANSI/AGMA 2001 -D04, Fundamental Rating Factors and Calculation Methods for Involute Spur and
Helical Gear Teeth
ANSI/AGMA 9003-C17, Flexible Couplings — Keyless Fits
ANS1/AGMA 9005-F 16, Industrial Gear Lubrication
ANSI/AGMA ISO 6336-6-A08, Calculation of Load Capacity of Spur and Helical Gears — Part 6:
Calculation of Serwce Life Under Variable Load
ANSI/AGMA 9002-C14, Bores and Keyways for Flexible Couplings (Inch Series)
DIN 6885-1:1968, Drive Type Fastenings without Taper Action; Parallel Keys, Keyways, Deep Pattern
3 Symbols and definitions
The symbols and definitions used in this standard may differ from those in other AGMA standards. The user should not assume that familiar symbols can be used without a careful study of the applicable section(s) and equation(s).
3.1 DefInitions
The terms used, wherever applicable, conform to the following standard:
ANSI/AGMA 1012-1305, Gear Nomenclature, Definitions of Terms with Symbols
3.2 Symbols
The symbols used in this standard are shown in Table 1.
NOTE: The symbols and terms contained in this document may vary from those used in other AGMA standards. Users of this standard should assure themselves that they are using these symbols and terms in the manner indicated herein.ANSI/AGMA 6001 pdf download.