IEC 62368-3-2018 pdf free download.Audio/video, information and communication technology equipment – Part 3: Safety aspects for DC power transfer through communication cables and ports.
The power transfer uses voltages at ES1 or ES2 or in very specific cases voltage levels at
ES3.
NOTE I ES1 can generally be assumed to have similar limits as non-hazardous voltage definitions used in other standards (for example, SELV. PELV).
NOTE 2 ES2 can generally be assumed to have similar limits for single fault conditions as non-hazardous voltage definitions used in other standards.
NOTE 3 PS2 circuits are generally expected to provide less than 100 W to an undefined load under both normal operating conditions and single fault conditions
EXAMPLES
— For power transfer using voltages at ESI: USB. PoE. ISDN SO. etc.
— For power transfer using voltages at ES2: analogue telephone during ringing. ISDN U, etc.
— For power transfer using voltages at ES3: power feeding used by communications service providers and utilities communication circuits (for example. RFT circuits, such as line powered HDSLx, SHDSLx. VDSLx and G.fast).
NOTE 4 Any cable provided with a connector defined by an industry standard that permits DC power transfer between equipment Is considered a communication cable even if communication does not take place. For example, a USB cable can be used just to recharge a portable device battery
This group safety publication is primarily intended to be used as a product safety standard for the products mentioned in the scope, but shall also be used by technical committees in the preparation of standards for products similar to those mentioned in the scope of this standard, in accordance with the principles laid down in IEC Guide 104 and ISO/IEC Guide 51.
One of the responsibilities of a technical committee is, wherever applicable, to make use of basic safety publications and/or group safety publications in the preparation of its publications.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
IEC 62368-1 :2014, Audio/video, information and communication technology equipment — Part 1: Safety requirements
IEC Guide 104, The preparation of safety publications and the use of basic safety publications and group safety publications
ISO/IEC Guide 51, Safety aspects — Guidelines for their inclusion in standards
3 Terms, definitions and abbreviated terms
3.1 Terms and definitions
For the purposes of this document, the terms and definitions given in IEC 62368-1:2014 and the following apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
— IEC Electropedia: available at http:/fwww.electropediaorg/
— ISO Online browsing platform: available at http:J/www.iso.org/obp
3.1.1 power sourcing equipment PSE equipment, other than dedicated external power supply units intended to supply specific equipment within the scope of IEC 62368-1. supplying DC power to other equipment through communication cables or ports
Note ito entry: It should be noted that the IEEE 802.3.2015 standard has a similar but different definition. Note 2 to entry: This note applies to the French language only.
3.1.2 powered device PD equipment supplied DC power by a PSE through communication cables or ports.IEC 62368-3 pdf free download.