BS F 152:2006 pdf free.Properties of siliconerubber sheet, mouldingsand extrusions (general purpose)-Specification.
BS F 152 This British Standard specifies requirements for silicone rubber material possessing excellent ozone resistance properties intended forthe production of items such as sheet, mouldings and certain extrusionsfor use in mainly mechanical applications in contact with air over thetemperature range  65C to 230°co.
This material standard is to be used in conjunction with BS EN 3207.NOTE 1 Material and products manafactured from this specification arenot intended for ligid sealing or for an application where low compression set is of prime importance.
NOTE 2 Occasional contamination by silicate ester and phosphate esterhadraulic fluids,di-ester greases is not unduly detrimental provided thetemperature is not excessive. Contact with fuels, light mineral oils,
silicone ligquids or greases derived from these should be avoided.NOTE 3 Further information on the suitability of silicone rubberfor design applications can be found in SBAC Technical SpecificationNo.97 [ 1 ].
NOTE 4 Marking BS F 152:2006 on or in relation to a product representsa manufacturer’s declaration of conformity, i.e. a claim by or on behalf ofthe manufacturer that the product meets the requirements of the standard.The accuracy of the claim is solely the claimant’s responsibility. Such adeclaration is not to be confused with third party certification of conformity.
The following referenced documents are indispensable for the application of this document. For dated references, only the referencecited applies.For undated references, the latest edition of the referenced document (including any amendments) applies.BS 903-A1 (ISO 2781), Physical testing of rubber – Part A1:Determination of density.
BS 903-A6 (ISO 815), Phaysical testing of vubber – Part A6: Methodfor determination of compression set at ambient, elevated or lowtemperatures.
BS 903-A26 (ISO 48), Physical testing of rubber – Part A26: Method.for determination of hardness (hardness betveen 10 IRHD and100 IRHD)
BS 3734-1(ISO 3302-1),Rubber – Tolerances for products -Part 1 : Dimensional tolerances.
BS EN 3207,Rubber compounds – Technical specification.
For the purposes of this British Standard,the following terms anddefinitions apply.BS F 152 pdf download.