BS EN 957-10:2005 pdf free.Stationary trainingequipment — Exercise bicycles with a fixed wheel or without freewheel, additional specific safety requirements and test methods.
BS EN 957-10 Training equipment where the pedal cranks have a greater diameter than the housing shall have a distance bet-ween the pedal cranks and the stationary parts of the construction of not less than 10 mm. This requirement doesnot apply if the housing has a greater diameter than the pedal crank.
Transmission elements shall be covered in accordance with EN ISO 12100-1.All other parts shall be tested withthe test finger in accordance with EN 957-1.The test finger shall not become trapped or come into contact withmoving parts which do not have a smooth surface. The radius of the edge of the flywheel shall be at least 2,5 mm.The edges of the pedals shall be free of burrs, rounded or protected in some other way.
Test in accordance with 6.1.1 and 6.2.
When tested in accordance with 6.3, accessible parts of the equipment shall not have a temperature greater than65 ℃.
For class S the seat pillar shall be tested with 4 times the maximum body mass specified by the manufacturer or4 000 N whichever is greater.For class H the seat pillar shall be tested with 3 times the maximum body massspecified by the manufacturer or 3 000 N whichever is greater. For both classes the pedals and the crank shall betested 4 times the maximum body mass specified by the manufacturer or 4 000 N whichever is greater.
Testing in accordance with 6.4.
The seat shall be in accordance with ISo 4210.
After the test in accordance with 6.4, the training equipment shall be capable of functioning according to the manu-facturer’s information on the correct use.
During the tests of the seat pillar and the pedals the training equipment shall not tip over.The clamped seat pillar shall not slip by more than 5 mm into the seat tube during the test.BS EN 957-10 pdf download.