BS EN 71-2:2006 pdf free.Safety of toys—Flammability.
BS EN 71-2 The following materials shall not be used in the manufacture of toys:
celluloid (cellulose nitrate), except when used in varnish, paint or glue,or in balls of the type used for tabletennis or similar games,and materials with the same behaviour in fire as celluloid. Specific materials to whichthe test flame is applied in order to check compliance of the toy with requirements in 4.2 to 4.5 are consideredto comply with this requirement if the toy meets its appropriate requirements in 4.2 to 4.5;
materials with a piled surface which produce surface flash on the approach of a flame. Piled surfaces showing no momentary area of flame over the area of the piled surface remote from the test flame are considered tomeet this requirement; highly flammable solids.
ln addition, toys shall not contain flammable gases, highly flammable liquids,flammable liquids，fammable gelsexcept as provided for below:flammable liquids, flammable gels and preparations supplied in sealed containers having a maximum volumeof 15 ml per container;
highly flammable liquids and flammable liquids being entirely retained within a porous material in capillary channels of writing instruments;
These materials may or may not be attached to masks, hats or other products worn on the head.
When tested in accordance with 5.2, the duration of flaming shall not be more than 2 s after the removal of the testflame.
In addition, if ignition occurs, the maximum burnt length of hair, pile, or material with similar features shall be:a) not more than 50 % of the greatest initial length, when the initial length was 150 mm or more;
b) not more than 75 % of the greatest initial length, when the initial length was less than 150 mm
When determining whether materials are required to be tested under 4.2.2, the distance by which the materialprotrudes shall be measured without applying tension to the protruding part, e.g. curly hair is not straightened.Plaits or braided hair shall be fully released and combed, where possible, before testing.
Beards, moustaches, wigs etc. made from hair, pile or material with similar features (e.g. freehanging ribbons, paper or cloth strands etc.), which protrude less than 50 mm from the surface of the toyThese materials may or may not be attached to masks, hats or other products worn on the head.
When tested in accordance with 5.3, the duration of flaming shall not be more than 2 s after the removal of the testflame, and the maximum distance between the upper edge of the burnt area and the point of application of the testflame shall not be more than 70 mm.BS EN 71-2 pdf download.