BS EN 40-2:2004 pdf free.Lighting columns—General requirements and dimensions.
BS EN 40-2 This document specifies the requirements and dimensions for lighting columns，brackets，basecompartments, cableways and earthing terminals. lt applies to post top columns not exceeding 20 mheight for post top lanterns and columns with brackets not exceeding 18 m height for side entry lanterns.
This Part does not attempt to restrict the actual appearance or shape of the column or bracket.Themajority of lighting columns are normally of a stepped tubular，round, octagonal or polygonal cross-section. Lighting columns may be manufactured from materials other than those listed in the foreword(e.g. wood， plastic, cast iron)or in other forms (e.g. lattice and telescopic).
This document specifies performance related to the essential requirements of resistance to horizontal(wind) loads and performance under vehicle impact (passive safety) in support of the EssentialRequirement No 4 Safety in use measured according to the corresponding test methods included inthis document or available in separate documents.
The following referenced documents are indispensable for the application of this document. For datedreferences, only the edition cited applies. For undated references, the latest edition of the referenceddocument (including any amendments) applies.
EN 40-1:1991, Lighting columns – Part 1: Definitions and terms
EN 755-8:1998,Aluminium and aluminium alloys – Extruded rod/bar,tube and profiles — Part 8:Porthole tubes, tolerances on dimensions and form
EN 10051,Continuously hot-rolled uncoated plate，sheet and strip of non-alloy and alloy steels 一Tolerances on dimensions and shape
EN 10210-2:1997,Hot finished structural hollow sections of non-alloy and fine grain structural steels-Part 2: Tolerances, dimensions and sectional properties
EN 10219-2:1997, Cold formed welded structural hollow sections of non-alloy and fine grain steels —Part 2: Tolerances, dimensions and sectional properties.
The position of the door opening or openings shall be as shown in Figure 3. Dimension c shall be not lessthan 300 mm. No maximum dimension is specified.
lt is recommended that dimension c should be approximately 600 mm.The door opening dimensions shall be a and b as shown in Figure 3.Typical door opening dimensions are shown in Table 5.BS EN 40-2 pdf download.