AS 7240.13:2021 pdf download.Fire detection and alarm systems Part 13: Compatibility assessment of system components (ISO 7240- 13:2018 (ED.2.0) MOD).
4 Requirements
4.1 Conformance
The components shall conform to the requirements of the ISO 7240 series or the ISO 6182 series or with a national equipment standard or with a manufacturer’s specification where a standard is not available.
National application guidelines (also known as codes of practice) also contain system requirements.
—Suppliers of components shall ensure that they meet the requirements of this document;
— meet the requirements of the application guidelines of the countries where the components are intended to be placed on the market.
In order to conform to this document, compatibility of the components type I or connectability of the components type 2 within the FDAS shall meet the requirements listed in Clause 4 of this document. This shall be verified by theoretical assessment (&1) with reference to the required documentation (Clause 8). When it is an outcome of the theoretical assessment, conflguration(sJ according to 5 shall be tested as described using the relevant selection of functional tests defined in 55 and & and shall meet the acceptance criteria of the tests.
4.2 General system requirements
4.2.1 The applicant shall provide a list of the FDAS devices and those devices not covered by the Iso 7240 series shall be declared as component type I or component type 2.
4.2.2 The different FDAS configurations intended to be used shall be described within the applicant’s documentation.
4.2.3 Each of the configurations declared by the applicant shall be considered and representative configurations shall be assessed to meet the requirements of this document.
4.2.4 Each component type 1 shall be powered directly or indirectly by a PSE which conforms to the requirements in ISO 7240-4, except for some radio link components in accordance with ISO 7240-25 which may be powered by batteries.
4.2.5 Each component type I shall meet the requirements of the relevant part of the ISO 7240 series or the ISO 6182 series.
Where the component type 1 is not covered by a relevant part of ISO 7240 series or the ISO 6182 series, it shall meet the following criteria:
a) conformity of the functionality (indication, control, activation) as declared by the component manufacturer: this functionality shall be consistent with the purpose of a FDAS. The applicant shall provide the means to check the functionality;
b) conformance to IEC 62599-2;
c) conformance to IEC 62599-1; the applicant shall declare the environmental class. The measurements or inspections are made before, during (if necessary) and after testing. There shall be no change in the functioning of the equipment and no significant change in any measurements, which shall also remain within specification.
Alternatively, the component may comply with the environmental clauses included in the relevant part of the ISO 7240 series (refer to ISO 7240-1 to classify the components and select the appropriate part).
NOTE It is possible for a component to be covered by a National Assessment Document where there is not an ISO 7240 standard.
4.2.6 The operation of type 1 and type 2 components shall not jeopardize the operation of the system.
4.2.7 Each component within the FDAS shall operate correctly when submitted to supply voltage variation as specified by the manufacturer. For each configuration, voltage shall be within the specified voltage supply range of each component in the FDAS.AS 7240.13 pdf download.