ANSI/AGMA 2005-C96 pdf free.American National Standard – Design Manual for Bevel Gears.
ANSI/AGMA 2005 contains information for me design. tabncation. inspection and mounting of bevel gears. The term bevel gears is used to mean straight, spiral, zerol bevel and hypoid gear designs. If the text pertains to one or more but not all, the specific forms are identified
The manufacturing process of forming the desired tooth form is not intended to imply any specific process, but rather to be general in nature and applicable to all methods of manufacture.
Precision finish, as used in this standard, refers to a machine flnishln9 operation which includes gnnding, skiving, and hard cut finishing. However, the common form of finishing known as lapping is speciflcdy excluded as a form of precision finishing.
Users should determine the cutting methods available from their gear manufacturer prior to proceeding. Cutting systems used by bevel gear manufacturers are heavily dependent upon the type of machine tool that will be used
This standard is intended for use by an experienced gear designer capable of selecting reasonable vaftes for the factors based on his knowledge and background. It is n intended for use by the engineenng public at large
2 References
The following documents contain provisions which, through reference in this text, constitute provisions of the standard. At the time of publication, the editions were vahd. All publications are subject to revision, and the users of this manual are encouraged to investigate the possibi’ity of applying the most recent edrtions of the publications listed.
3 Symbols terms and definitions
The symbols, terms, and definitions used in this standard are, wherever possible, consistent with other approved AGMA documents it is known, because of certain limitations, that some symbols, their titles, and their definitions, as used in this document, are different than in similar literature pertaining to spur and helical gearing.
Bevel gear nomenclature used throughout this standard is lustrated in figure 1, the axial section of a bevel gear, and in figure 2, the mean transverse section. Hypoid nomenclature is illustrated In figure
3.1 Symbols
Table I is a hat of the symbols used in this standard, along with the associated terms, The “Where first used” column gives the clause or equation number where the particular symbol Is first used.
3.2 DefinitIon of terms
addendum of gear, mean, Go: The height by which the gear tooth projects above the pitch cone at the mean cone distance
addendum of pinion, mean, a: The height by which the pinion tooth projects above the pitch cone at the mean cone distance.ANSI/AGMA 2005 pdf free download.