BS EN 2997-005:2016 pdf free.Aerospace series — Connectors, electrical, circular,coupled by threaded ring, fire-resistant or non fire-resistant,operating temperatures —65 °C to 175 C continuous,200 °C continuous,260 C peak Hermetic square flange receptacle— Product standard.
BS EN 2997-005 This European Standard specifies the characteristics of hermetic square flange mounted receptacles inthe family of circular electrical connectors coupled by threaded ring.
lt applies to the class defined in Table 3.
For plugs and protective covers, see EN 2997-008 and EN 2997-009 respectively.
2Normative references
The following documents, in whole or in part, are normatively referenced in this document and areindispensable for its application. For dated references,only the edition cited applies. For undatedreferences, the latest edition of the referenced document (including any amendments) applies.
EN 2997-001,Aerospace series —Connectors, electrical, circular, coupled by threaded ring, fire-resistantor non fire-resistant, operating temperatures -65 C to 175 C continuous, 200 °C continuous, 260 °C peak—Part 001: Technical specification
EN 2997-002,Aerospace series —Connectors, electrical, circular, coupled by threaded ring, fire-resistantor non fire-resistant, operating temperatures -65 C to 175 C continuous, 200 °C continuous, 260 °C peak—Part 002: Specification of performance and contact arrangements
EN 2997-008,Aerospace series —Connectors, electrical, circular, coupled by threaded ring, fire-resistantor non fire-resistant, operating temperatures -65 C to 175 C continuous, 200 °C continuous, 260 C peak.—Part 008: Plug -Product standard
EN 2997-009, Aerospace series —Connectors, electrical, circular, coupled by threaded ring, fire-resistantor non fire-resistant, operating temperatures -65 C to 175 C continuous, 200 °C continuous, 260 °C peak- Part 009: Protective cover for receptacle — Product standard
Dimensions and massSee Figure 1 and Table 1.
Dimensions and tolerances are in millimetres; they apply after surface treatment.
Unless there are other specific contractual requirements, the marking shall include:
— the identity block as defined in Clause 5;
— the date of manufacture (year, week);
— the manufacturer’s name or trade mark.BS EN 2997-005 pdf download.