AS/NZS 60335.2.79:2017 pdf free.Household and similar electrical appliances – Safety Part 2.79: Particular requirements for high pressure cleaners and steam cleaners.
7 Marking and instructions
This clause of Part us applicable except as follows.
7.1 Modification:
Replace the 41h dashed item as follows:
— the business name and address of the manufacturer and, if applicable, his authorized representative; any address shall be sufficient to ensure postal contact;
Addition:
Machines shall be marked in addition with the following:
— serial number, if any;
— designation of the machine and series or type, allowing the technical identification of the product. This may be achieved by a combination of letters and/or numbers;
NOTE 101 Designation of machine, series or type includes the model or type reference as required in Part 1.
— year of construction, i.e. the year in which the manufacturing process is completed;
— rated pressure in Pascal;
allowable pressure in Pascal;
— rated flow in litre per minute;
— maximum flow rate in litre per minute, if necessary. The number of flow rate markings is limited to two:
— maximum rated temperature where this is above 50 °C;
— maximum power of the water heater in kW, if applicable (for electric heaters, the input power, for gas-fired or oil-fired heaters the output power).
Machines equipped with wheels and other mobile machinery shall be marked with the mass of the most usual configuration in kg.
A yellow label with black lines showing the substance of the warning symbols in accordance with Figure 101 shall be permanently fixed to the machine.
Machines shall be marked in addition with the following, if applicable:
— When the surface of a flue or duct for exhaust gases from the heater exceeds a temperature rise of 60 K, a warning notice shall be fitted near to the hot surface stating
WARNING Hot. Do not touch.
The height of the lettering shall be not less than 4 mm. This wording may be replaced by symbol lEG 60417-5041(2002-10).
— Steam cleaners shall be marked with symbol IEC 60417-5597 (2014-06).
— Machines not intended to be connected to the potable water mains shall be marked with the symbol according to Figure 104, coloured as shown or in monochrome colour.
— Machines intended to be used indoors and powered by internal combustion engines, except LPG-powered engines, shall be marked with the symbol according to Figure 105. It is acceptable to show this symbol in monochrome colour.
7.1.101 All high pressure hoses shall be marked with the following:
— with a pressure of at least the allowable pressure in Pascal;
— maximum temperature in degrees Celsius;
— business name of the manufacturer of the hose and the date of production. These data may be coded.
Compliance is checked by inspection.
7.1.102 All high pressure accessories (e.g. trigger gun, spray lance) shall be marked with
the following:
— a pressure of at least the allowable pressure in Pascal;
— maximum temperature in degrees Celsius.
Compliance is checked by inspection.
7.1.103 Motorized cleaning heads shall be marked with
— rated voltage or rated voltage range in volts;
— rated power input in watts;
— name, trade mark or identification mark of the manufacturer or responsible vendor;
— model or type reference;
— year of construction, i.e. the year in which the manufacturing process is completed;
— mass of the most usual configuration in kg.AS/NZS 60335.2.79 pdf download.