AS ISO 13007.5:2020 pdf free.Ceramic tiles – Grouts and adhesives Part 5: Requirements, test methods, evaluation of conformity, classification and designation of liquid-applied waterproofing membranes for use beneath ceramic tiling bonded with adhesives.
5 Evaluation of conformity
5.1 General
The liquid-applied waterproofing membrane shall be considered conformant if test results indicate compliance with all of the fundamental characteristics listed in Table 1. For those products claiming the optional classifications in Clause 5, test results must also indicate compliance with the optional characteristics listed in Table 2.
5.2 Reaction to fire
Reaction to fire may be of concern in individual countries, and may need to be considered in light of local standards or regulatory requirements
6 Classification and designation
The liquid-applied waterproofing membranes are classified into one of the three types, according to the definitions given in Clause 3:
CM cementit ious liquid-applied waterproofing membrane;
DM dispersion liquid-applied waterproofing membrane;
RM reaction resin liquid-applied waterproofing membrane.
For each type it is possible to have different classes, related to the different optional characteristics given in Table 2. These classes are designated by the following abbreviations:
01 with improved crack bridging ability at —5°C;
02 with improved crack bridging ability at —20°C;
P resistant to contact with chlorinated water (i.e. for use in swimming pools).
The product is designated by the symbol for the type (CM, DM or RM), followed by the abbreviation of the class or classes it belongs to. Table 3 describes the designation of the products types and classes which shall be used.
7 Marking and labelling
Products complying with the requirements of this part of ISO 13007 shall be clearly marked with the following information:
a) name of the product;
b) manufacturer’s mark and place of origin;
c) date or code of production, shelf life and conditions of storage;
d) dated reference to this part of ISO 13007, i.e. ISO 13007-5:2015;
e) type of product according to Clause 6 and using symbols given in Clause 6
f) instructions for use:
— mix proportions (where applicable);
— maturing time (where applicable);
— potlife;
— mode of application (including recommended primer and/or reinforcement mesh);
— minimum quantity or thickness of the product as applied wet as well as the final cured
film thickness;
— delay for installing ceramic tiles;
— suitable adhesive(s), type and class in accordance with ISO 13007-1;
— field of application (internal, external, wall, floor etc.)
In the designation of a liquid-applied waterproofing membrane, information about special properties may also be included when the product is intended for use in specific applications.
This information shall be marked on the packaging and/or on the product’s technical data sheet.
NOTE This does not remove the requirement that all manufacturers claiming compliance with this part of Iso 13007 state declared values for the properties of their products, when required.AS ISO 13007.5 pdf download.